Universal Remote DMS-100 Especificações descarregar pdf (Página 94)

3-26 Ringing in Series II peripherals

297-1001-131 Standard 06.01 October 2000

Ringing generator conﬁguration change procedure

Follow this procedure to change the ringing conﬁguration in host and remote

line concentrating module (LCM) conﬁgurations. During this procedure, the

LCM units enter an in-service trouble (ISTb) state because of ringing cadence

differences. The ISTb state clears after you or the system starts a test. Perform

this procedure during a low trafﬁc period.

The test lines off the LCM that you modify for this procedure should be set up

and in good working order before beginning this procedure. Use the test lines

during this procedure to test the changes in the ringing scheme.

In the unlikely event that something occurs and obstructs the ringing system,

back out of the procedure by reversing the steps you entered. If a serious

problem exists, such as an E1 outage, immediately contact Emergency

Technical Assistance Support (ETAS).

Dual LCM conﬁguration

This procedure describes how to reconﬁgure the ringing generators in host and

remote switching center (RSC) dual LCM conﬁgurations. The procedure

begins with the reconﬁguration of ringing generator 1 and then reconﬁgures

ringing generator 0. For the following procedure, the LCM site is HOST. The

frame number is 0. The units affected are 0 and 1. These values are for example

only. Operating company personnel must use site, frame, and unit LCM values

for the affected LCMs.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 133 134

Sem comentários

Universal Remote DMS-100 Especificações Página 94